Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Windshield Garnish Molding Replacement

Preliminary Procedure

Preliminary Procedure

Disable the SIR system. Refer to SIR Disabling and Enabling.

  1. Windshield Garnish Molding Assembly

Procedure

  1. Loosen  tether clip and steel clips.
  2. Disconnect electrical connector.
  3. The tether clip at the upper portion of the garnish molding MUST be replaced any time the garinish molding is removed.
Front Side Door Trim Replacement
Front Side Door Pull Handle Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 2 N·m (18 lb in) Front Side Door Inside Handle Bolt Finish Cap Tip Pull handle ...

Center Pillar Upper Garnish Molding Replacement
Preliminary Procedure Remove the center pillar lower garnish molding. Refer to Center Pillar Lower Ga   rnish Molding Replacement Remove the seat belt from the front seat. Refer ...

Other materials:

Floor Mats
WARNING If a floor mat is the wrong size or is not properly installed, it can interfere with the pedals. Interference with the pedals can cause unintended acceleration and/or increased stopping distance which can cause a crash and injury. Make sure the floor mat does not interfere with the p ...

Traction Control System (TCS)/StabiliTrak® Light
The StabiliTrak or Traction Control System (TCS) indicator/warning light comes on briefly when the engine is started. If the light does not come on, have the vehicle serviced by your dealer. If the system is working normally, the indicator light turns off. If the light is on and not flashing, ...

Engine Coolant
The cooling system in the vehicle is filled with DEX-COOL engine coolant. This coolant is designed to remain in the vehicle for 5 years or 240 000 km (150,000 mi), whichever occurs first. The following explains the cooling system and how to check and add coolant when it is low. If there is a ...

© 2017-2021 Copyright www.crion.site