Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Wheel Stud Replacement

Removal Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting  and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  3. Remove the wheel bearing/hub. Refer to Rear Wheel Bearing and Hub Replacement.

Caution: Support the brake caliper with heavy mechanic wire, or

Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

  1. Release the wheel stud (1) from the bearing hub with the hydraulic press and discard the stud.

Installation Procedure

  1. Install a NEW stud into the bearing/hub assembly (2). Add enough washers (3) in order to draw the stud into the hub.
  2. Install and tighten a wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing/hub flange (2).
  3. Remove the wheel nut (1) and the washers (3).
  4. Install the wheel bearing/hub (2). Refer to Rear Wheel Bearing and Hub Replacement.
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  6. Remove the support and lower the vehicle.
Rear Axle Replacement
Special Tools EN 45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and suitably support the vehicle. Refer to Lifting   and ...

Rear Suspension Description and Operation
This vehicle has a semi-independent twist-beam rear suspension system consisting of the following components: An axle with integral trailing arms AV shaped twisting cross beam Two coil sprin ...

Other materials:

Battery Negative Cable Disconnection and Reconnection
Removal Procedure Turn on the radio and record all of the customer radio station presets. Ensure that all lamps and accessories are turned off. Turn the ignition OFF and remove the ignition key. Warning: Refer to Battery Disconnect Warning in the Preface section. Loosen the negati ...

Retained Accessory Power (RAP)
These vehicle accessories may be used for up to 10 minutes after the engine is turned off: • Audio System • Power Windows • Sunroof The power windows and sunroof will continue to work for up to 10 minutes or until any door is opened. The radio will work when the key is in ON/RUN or ACC/ ACCE ...

Navigation Symbols
Following are the most common symbols that appear on a map screen. The vehicle symbol indicates the current position and heading direction of the vehicle on the map. The destination symbol marks the final destination after a route has been planned. The waypoint symbol marks one or more se ...

© 2017-2021 Copyright www.crion.site