Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Wheel Stud Replacement

Special Tools

CH-43631 Ball Joint Remover

For equivalent regional tools, refer to Special Tools.

Removal Procedure

  1. Raise and suitably support the vehicle. Refer to Lifting  and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  3. Remove and support the brake caliper and bracket as an assembly, and remove the brake rotor. Refer to Front Brake Rotor Replacement.
  4. Rotate the bearing hub to a position where the least amount of interference between the stud and the steering knuckle exists.

Caution: Support the brake caliper with heavy mechanic wire, or

Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

  1. Using the CH-43631 remover (2) release the wheel stud (1) from the bearing hub and discard the stud (1).

Installation Procedure

  1. Install a NEW stud into the bearing/hub assembly (2). Add enough washers (3) in order to draw the stud into the hub.
  2. Install and tighten a wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing/hub flange (2).
  3. Remove the wheel nut (1) and the washers (3).
  4. Install the brake rotor, and install the brake caliper and bracket as an assembly. Refer to Front Brake Rotor Replacement.
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  6. Lower the vehicle.
Front Lower Control Arm Bushing Replacement
Preliminary Procedure Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation. Remo ...

Strut Assembly Replacement
Special Tools CH 49375 Wrench For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and the vehicle. Refer to Lifting and Jacking the Vehicle. Remove the tire and whe ...

Other materials:

Instrument Panel Illumination Control
This feature controls the brightness of the instrument panel controls and infotainment display screen. The thumbwheel is to the left of the steering column on the instrument panel. (Instrument Panel Brightness): Move the thumbwheel up or down and hold, to brighten or dim the instrument pan ...

Installation Procedure
Create 6 x 20 mm (4/16 x 11/16 in) slots for MIG-brazing along the upper edges of the service panel as noted from the original panel. Clean and prepare the attaching surfaces for brazing and spot welding. Position the body lock pillar inner panel on the vehicle. Verify the ...

Transmission
Driver Shift Control (DSC) allows the automatic transmission to be shifted similar to a manual transmission. Electronic Range Select (ERS) allows for the selection of a range of gears. Up-Shift Light If the vehicle has a manual transmission, it will have an up-shift light that indicates whe ...

© 2017-2021 Copyright www.crion.site