Move the lever all the way up or down to signal a turn.
An arrow on the instrument cluster will flash in the direction of the turn or lane change.
Raise or lower the lever until the arrow starts to flash to signal a lane change. The turn signal flashes three times.
The lever returns to its starting position when it is released.
If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb may be burned out. Replace any burned out bulbs. If a bulb is not burned out, check the fuse.
Hood Hold-Open Rod Replacement
Warning: Refer to Hood Hold-Open Device Warning in the Preface section.
Preliminary Procedure
Remove the radiator grille reinforcement support. Refer to Radiator Grille
Reinforcement Support Replacement.
Hood Hold Open Rod Pivot (Qty: 2)
Hood Hold Open Rod
...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR Disabling
and Enabling.
Disconnect the negative battery cable. Refer to Batter ...
Accident With Side Air Bag Module Deployment - Component Replacement and
Inspections
After a collision involving left/right side air bag module deployment,
replace the following components.
Left/right inflatable restraint side impact sensors on the side of the
impact.
Left/right inflatable restraint roof rail module on the side of the
impact.
Inflatable restraint sen ...