Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Traction Control System (TCS)

The vehicle has a Traction Control System (TCS) that limits wheel spin.

On a front-wheel-drive vehicle, the system operates if it senses that one or both of the front wheels are spinning or beginning to lose traction. When this happens, the system brakes the spinning wheel(s), and/or reduces engine power to limit wheel spin.

The system may be heard or felt while it is working, but this is normal.

TCS is on whenever the vehicle is started. To limit wheel spin, especially in slippery road conditions, the system should always be left on. But, TCS can be turned off if needed.

TCS/StabiliTrak Light

TCS/StabiliTrak Light

control system is active. flashes to indicate that the traction control system is active.

If there is a problem detected with TCS, SERVICE TRACTION CONTROL and SERVICE STABILITRAK may be displayed on the Driver Information Center (DIC).

When this message is displayed and d comes on and stays on, the vehicle is safe to drive but the system is not operational.

Driving should be adjusted accordingly.

If system:comes on and stays on, reset the system:
1. Stop the vehicle.

2. Turn the engine off and wait 15 seconds.

3. Start the engine.

If a speed above 20 km/h (13 mph), see your dealer for service. still comes on and stays on at a speed above 20 km/h (13 mph), see your dealer for service.

A chime may also sound when the light comes on steady.

Notice: Do not repeatedly brake or accelerate heavily when TCS is off. The vehicle's driveline could be damaged.

TCS/StabiliTrak Button

TCS/StabiliTrak Button

is located on the console.

TCS Off Light

TCS Off Light

TCS can be turned off by pressing and releasing comes on and the system will not limit. When TCS is turned off, wheel spin. comes on and the system will not limit wheel spin.

Driving should be adjusted accordingly. Press and release It may be necessary to turn the system off if the vehicle gets stuck in sand, again to turn the system back on.

It may be necessary to turn the system off if the vehicle gets stuck in sand, mud, or snow and rocking the vehicle is required. If cruise control is being used when TCS activates, cruise control will automatically disengage. Press the cruise control button to reengage when road conditions allow.Adding non-GM accessories can affect the vehicle's performance.

Ride Control Systems
...

StabiliTrak® System
The vehicle has a vehicle stability enhancement system called StabiliTrak. It is an advanced computer controlled system that assists with directional control of the vehicle in difficult driving co ...

Other materials:

Electrical System Overload
The vehicle has fuses and circuit breakers to protect against an electrical system overload. When the current electrical load is too heavy, the circuit breaker opens and closes, protecting the circuit until the current load returns to normal or the problem is fixed. This greatly reduces the c ...

Front End Upper Tie Bar Support Sectioning (MAG Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. W ...

Steering Wheel and Column Description and Operation
The steering wheel and column has 4 primary functions: Vehicle steering Vehicle security Driver convenience Driver safety Vehicle Steering The steering wheel is the first link between the driver and the vehicle. The steering wheel is fastened to a steering shaft within the column. A ...

© 2017-2022 Copyright www.crion.site