Every new GM vehicle has high-quality tires made by a leading tire manufacturer. See the warranty manual for information regarding the tire warranty and where to get service. For additional information refer to the tire manufacturer.
WARNING
• Poorly maintained and improperly used tires are dangerous.
• Overloading the tires can cause overheating as a result of too much flexing.
There could be a blowout and a serious crash.
• Underinflated tires pose the same danger as overloaded tires. The resulting crash could cause serious injury.
Check all tires frequently to maintain the recommended pressure.
Tire pressure should be checked when the tires are cold.
• Overinflated tires are more likely to be cut, punctured, or broken by a sudden impact— such as when hitting a pothole. Keep tires at the recommended pressure.
• Worn or old tires can cause a crash. If the tread is badly worn, replace them.
• Replace any tires that have been damaged by impacts with potholes, curbs, etc.
• Improperly repaired tires can cause a crash. Only the dealer or an authorized tire service center should repair, replace, dismount, and mount the tires.
• Do not spin the tires in excess of 56 km/h (35 mph) on slippery surfaces such as snow, mud, ice, etc. Excessive spinning may cause the tires to explode.
Low-Profile Tires
If the vehicle has P225/45R18 size tires, they are classified as low‐profile
tires. These tires are designed for very responsive driving on wet or dry pavement,
however, may produce more road noise and tend to wear faster.
Notice: Low-profile tires are more susceptible to damage from road ...
Service Vehicle Messages
SERVICE AC SYSTEM
This message displays if there is a problem with the air conditioning system.
Take the vehicle to your dealer for service.
SERVICE POWER STEERING
This message displays if there is a problem with the power steering system. Take
the vehicle to your dealer for service.
SERVICE ...
Installation Procedure
Cut the front hinge pillar body in corresponding locations to fit the
remaining original panel. The sectioning joint should be trimmed
to allow a gap of one-and-one-half-times the metal thickness at the
sectioning joint.
Create a 50 mm (2 in) backing plate from the unused portion of ...