Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Tire Designations

Tire Size

The following is an example of a typical passenger vehicle tire size.

(1) Passenger (P-Metric) Tire: The United States version of a metric tire

(1) Passenger (P-Metric) Tire:

The United States version of a metric tire sizing system. The letter P as the first character in the tire size means a passenger vehicle tire engineered to standards set by the U.S. Tire and Rim Association.

(2) Tire Width:

The three-digit number indicates the tire section width in millimeters from sidewall to sidewall.

(3) Aspect Ratio:

A two-digit number that indicates the tire height-to-width measurements.

For example, if the tire size aspect ratio is 60, as shown in item 3 of the illustration, it would mean that the tire's sidewall is 60 percent as high as it is wide.

(4) Construction Code:

A letter code is used to indicate the type of ply construction in the tire.

The letter R means radial ply construction; the letter D means diagonal or bias ply construction; and the letter B means belted-bias ply construction.

(5) Rim Diameter:

Diameter of the wheel in inches.

(6) Service Description:

These characters represent the load index and speed rating of the tire. The load index represents the load carrying capacity a tire is certified to carry. The speed rating is the maximum speed a tire is certified to carry a load.

Tire Sidewall Labeling
Useful information about a tire is molded into its sidewall. The examples show a typical passenger vehicle tire and a compact spare tire sidewall. Passenger (P-Metric) Tire Example (1) Tire Size ...

Tire Terminology and Definitions
Air Pressure: The amount of air inside the tire pressing outward on each square inch of the tire. Air pressure is expressed in kPa (kilopascal) or psi (pounds per square inch). Accessory Weight: ...

Other materials:

Luggage Compartment Description and Operation
Rear Compartment Lid Release System Components Body control module (BCM) Exterior rear compartment lid release switch Rear compartment lid release actuator Rear compartment lid release relay Rear Compartment Lid Release Operation When the exterior rear compartment lid release switch is ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR Disabling ...

Installation Procedure
Create 6 x 20 mm (4/16 x 11/16 in) slots for MIG-brazing along the upper edges of the service panel as noted from the original panel. Clean and prepare the attaching surfaces for brazing and spot welding. Position the body lock pillar inner panel on the vehicle. Verify the ...

© 2017-2021 Copyright www.crion.site