Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Steering Linkage Inner Tie Rod Replacement (Electronic Power Steering)

Chevrolet Cruze Repair Manual / Steering / Power Steering / Steering Linkage Inner Tie Rod Replacement (Electronic Power Steering)

Special Tools

CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod

For equivalent regional tools, refer to Special Tools.

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  3. Remove the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement.
  4. Remove the steering gear boot. Refer to Steering Gear Boot Replacement.

  1. Remove the steering linkage inner tie rod with CH-6247 remover/installer .

Installation Procedure

  1. Apply threadlock compound to the threads of the inner tie rod.

Caution: Refer to Fastener Caution in the Preface section.

  1. Install the steering linkage inner rod using the CH-6247 remover/installer and tighten to 105 N·m (77 lb ft).
  2. Install the steering gear boot. Refer to Steering Gear Boot Replacement.
  3. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement.
  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
  5. Measure the wheel alignment. Refer to Wheel Alignment Measurement.
  6. Adjust front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment.
  7. Center the steering angle sensor. Refer to Steering Angle Sensor Centering.
Steering Linkage Inner Tie Rod Replacement (Hydraulic Power Steering)
Special Tools CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle ...

Power Steering System Description and Operation
The hydraulic power steering pump is a constant displacement vane-type pump that provides hydraulic pressure and flow for the power steering gear. The hydraulic power steering pumps are either belt ...

Other materials:

Instrument Panel Outer Air Outlet Duct Replacement
Preliminary Procedure Remove instrument panel assembly. Refer to Instrument Panel Assembly Replacement. Instrument Panel Outer Air Outlet Duct Screw (Qty: 7) Caution: Refer to Fastener Caution in the Preface section. Tighten 2.5 N·m (22 lb in) Instrument Panel Outer Air Outlet Duct Floo ...

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the braze holes every 40 mm (1½ in). Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges of the rear floor panel filler as noted from the original panel. Clean and prepare ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to ...

© 2017-2021 Copyright www.crion.site