Chevrolet Cruze Repair Manual: Seat Belt System Description and Operation

Seat Belt Latch Stop Installation

Preliminary Procedure Locate the hole in the seat belt webbing where the original seat belt stop button was located. If the original hole in the seat belt webbing is not visible, perform ...

Restraint System

Note: If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision for additional information. Vehicle has front and rear seat belts that are the primary mean ...

Other materials:

Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of the serv ...

Operation
Controls The infotainment system is operated by using the pushbuttons, multifunction knobs, menus shown on the display, and steering wheel controls, if equipped. Turning the System On or Off (Volume/Power): Press to turn the system on and off. Automatic Switch-Off If the infotainment syste ...

Rear Side Door Check Replacement
Preliminary Procedure Remove rear side door trim panel. Refer to Rear   Side Door Trim Replacement Remove the rear side door water deflector. Refer to Rear Side Door Water Deflector Replacement Rear Side Door Check Bolt Caution: Refer to Fastener Caution in the Pre ...