Chevrolet Cruze manuals

Chevrolet Cruze Owners Manual: Safety Locks

The rear door safety locks prevent passengers from opening the rear doors from inside the vehicle.

Press  to activate the safety locks.

Press The indicator light comes on when activated. to activate the safety locks. The indicator light comes on when activated.

The rear door power windows are also disabled.

Press locks and power windows. again to deactivate the safety locks and power windows.

If the indicator light flashes, the feature may not be working properly.

If a rear door handle is pulled when the safety lock is deactivated, that door will remain locked and the indicator light may flash. Release the handle, then press the safety lock twice to deactivate the safety locks.

Automatic Door Locks
Automatic Door Lock The doors are programmed to automatically lock when the shift lever is moved out of P (Park). The automatic door lock feature cannot be disabled. Automatic Door Unlock The do ...

Doors
Trunk WARNING Exhaust gases can enter the vehicle if it is driven with the liftgate, trunk/hatch open, or with any objects that pass through the seal between the body and the trunk/hatch or lift ...

Other materials:

Windshield Washer Pump Replacement
Removal Procedure Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement. Disconnect the washer pump electrical connector (1). Disconnect the washer pump hose (2) from the washer pump (3). Using a small flat-bladed tool, remove the washer pump from the washer ...

Map Data Updates
The map data in the vehicle is the most up-to-date information available when the vehicle was produced. The map data is updated periodically, provided that the map information has changed. For questions about the operation of the navigation system or the update process, contact the GM Nav Dis ...

Installation Procedure
Cut the quarter outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion  ...

© 2017-2021 Copyright www.crion.site