SERVICE TRACTION CONTROL
This message displays when there is a problem with the Traction Control System (TCS).
SERVICE STABILITRAK
This message displays if there is a problem with the StabiliTrak system.
Installation Procedure
Clean and prepare the attaching surfaces for welding.
Apply one-part windshield urethane adhesive as noted from the original
panel.
Position the roof panel (1) on the
vehicle.
Verify the fit of the panel.
Clamp the panel into position.
Spot weld accor ...
Starting the Engine
Place the transmission in the proper gear.
Notice: If you add electrical parts or accessories, you could change
the way the engine operates. Any resulting damage would not be covered by the vehicle
warranty.
Automatic Transmission
Move the shift lever to P (Park) or N (Neutral). The engine wi ...
Rear Compartment Lid Emblem/Nameplate Replacement (Chevrolet)
Rear Compartment Lid Emblem Assembly
Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface
section.
Procedure
The part and surface should be 21°C (70°F) prior to installation. The
vehicle should remain 21°C (70°F) for
one hour after assembly to allow adhesive to deve ...