Chevrolet Cruze Repair Manual: Removal Procedure
- Remove the drivetrain and front suspension frame. Refer to Drivetrain and Front Suspension Frame Replacement.
- Mark Installation position of insulator (2) at frame (1).
- Cut out frame insulator core (1) from frame insulator (2).
Note: On the rear insulator drill holes into the rubber in order to gain free access for jigsaw.
- Remove frame insulator core (1) from outer frame insulator (2).
- Cast out frame insulator (3) from drivetrain and front suspension frame (1) with CH-48377-1 chisel (2).
Drivetrain and Front Suspension Frame Insulator Replacement
Special Tools
CH 49460-1 Adapter
CH 49460-2 Adapter
CH 6616 Hydraulic Hand Pump
CH 6615-10 Hydraulic Cylinder
CH-48377-1 Chisel
For equivalent regional tools. Refer to Special Tools. ...
Installation Procedure
Install the following components on the drivetrain and front suspension
frame:
CH 49460-1 adapter (2).
CH 49460-2 adapter (4).
CH 6615-10 hydraulic cylinder (1).
NEW frame insula ...
Other materials:
Installation Procedure
Note: If the location of the original plug weld holes can not be
determined, space the braze holes every 40 mm (1½ in).
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges
of the rear floor panel filler as noted from the original
panel.
Clean and prepare ...
Windshield Wiper/Washer
The windshield wiper/washer lever is on the right side of the steering column.
With the ignition in ACC/ ACCESSORY or ON/RUN, move the windshield wiper lever to
select the wiper speed.
HI: Use for fast wipes.
LO: Use for slow wipes.
INT: (Intermittent Wipes): Move the lever up to INT for ...
Automatic Transmission Shift Lock Control Function Check
WARNING
When you are doing this inspection, the vehicle could move suddenly. If the
vehicle moves, you or others could be injured.
1. Before starting this check, be sure there is enough room around the vehicle.
It should be parked on a level surface.
2. Firmly apply the parking brake.
Be rea ...