Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the body rear end panel.

Note: Drill factory welds in area of the rear end upper panel reinforcement (1) from above. Drill holes are necessary for later plug welds.

  1. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the tail lamp pocket.
Tail Lamp Pocket Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the tail lamp pocket as noted  from the original panel. Note: Clean and prepare the attaching surfaces for welding. ...

Other materials:

Installation Procedure
Cut the quarter outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion &nbs ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Dis ...

Air Conditioning Evaporator Hose Assembly Replacement
Preliminary Procedures Recover the refrigerant. Refer to Refrigerant Recovery and Recharging. Remove the headlamp - right side. Refer to Headlamp Replacement. Loosen power steering fluid reservoir screw. Remove brake pipes from the dash lower extension panel. Remove engine mount. Ref ...

© 2017-2021 Copyright www.crion.site