Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the rear floor panel filler.

Note: Note the number and location of welds for installation of the service assembly.

  1. Drill all factory welds.

  1. Remove the rear floor panel filler.
Rear Floor Panel Filler Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the braze holes every 40 mm (1½ in). Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along ...

Other materials:

Tire Pressure Light
For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS. When the Light Is On Steady This indicates that one or more of the tires are significantly underinflated. A Driver In ...

When Should an Airbag Inflate?
This vehicle has advanced technology frontal airbags. Frontal airbags are designed to inflate in moderate to severe frontal or near frontal crashes to help reduce the potential for severe injuries, mainly to the driver's or front outboard passenger's head and chest. However, they are ...

Tail Lamp Replacement
Preliminary Procedures Open and support   the rear compartment lid. Remove the body side trim panel replacement in order to expose the tail lamp pocket nuts. Refer to Body Side Trim Panel Replacement - Left Side. Tail Lamp Bolt (Qty: 2) Caution: Refer to Fastener Caut ...

© 2017-2021 Copyright www.crion.site