Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the rear floor panel filler.

Note: Note the number and location of welds for installation of the service assembly.

  1. Drill all factory welds.

  1. Remove the rear floor panel filler.
Rear Floor Panel Filler Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Drill 8 mm (5/16 in) for plug welding along the edges of th ...

Other materials:

Front Side Door Trim Replacement
Front Side Door Pull Handle Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 2 N·m (18 lb in) Front Side Door Inside Handle Bolt Finish Cap Tip Pull handle back to remove cap. Use suitable tool to unsnap. Front Side Door Inside Handle Bolt Tighten ...

Infants and Young Children
Everyone in a vehicle needs protection! This includes infants and all other children. Neither the distance traveled nor the age and size of the traveler changes the need, for everyone, to use safety restraints. In fact, the law in every state in the United States and in every Canadian province ...

Remote Vehicle Start
For vehicles with this feature, the engine can be started from outside the vehicle. Starting the Vehicle 1. Aim the RKE transmitter at the vehicle. 2. Press and release . 3. Immediately after completing Step 2, press and hold for at least two seconds or until the turn signal lamps flash. Wh ...

© 2017-2021 Copyright www.crion.site