Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the rear side rail.

Note: Do not damage any other panels or reinforcements.

Note: Do not damage any other panels or reinforcements.

  1. Cut the panel where sectioning is to be performed.

  1. Locate and mark all the necessary factory welds of the rear side rail.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove  the damaged rear side rail.
Rear Rail Sectioning (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Cut the rear side rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness a ...

Other materials:

Rear Seat Back Cushion Cover and Pad Replacement - Left Side
Preliminary Procedure Remove rear seat - left side. Refer to Rear Seat Replacement Rear Seat Back Cushion Cover Procedure Remove the staples  from the seat back cover. Remove seat back cushion cover from Velcro. Rear Seat Back Cushion Pad Rear Seat Back Cushion Cover and Pad Re ...

Heated Front Seats
WARNING If you cannot feel temperature change or pain to the skin, the seat heater may cause burns. To reduce the risk of burns, people with such a condition should use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates again ...

Exterior Lamp Controls
The exterior lamp control is to the left of the steering column on the instrument panel. There are four positions: (Off): Briefly turn to this position to turn the automatic lamp control off or on again. AUTO (Automatic): Turns the headlamps on automatically at normal brightness, togethe ...

© 2017-2021 Copyright www.crion.site