Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the quarter outer panel.

Note: Do not damage any inner panels or reinforcements.

Note: Do not damage any inner panels or reinforcements.

  1. Cut the panel where sectioning is to be performed.

  1. Open the wheelhouse flanging.

  1. Locate and mark all the necessary factory welds of the quarter outer panel.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged quarter outer panel.
Quarter Outer Panel Sectioning (MAG-Welding)
Special Tools BO-6396 Bonding Pliers BO-6392 Flanging Tool Kit For equivalent regional tools, refer to Special Tools Note: According to different corrosion warranties, only the regional ma ...

Installation Procedure
Cut the quarter outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickn ...

Other materials:

Auxiliary Devices
This vehicle has an auxiliary input jack in the center console. Possible auxiliary audio sources include: • Laptop computer • MP3 player • Tape player This jack is not an audio output. Do not plug headphones into the auxiliary input jack. Set up any auxiliary device while the vehicle is in ...

Vehicle Data Recording and Privacy
The vehicle has a number of computers that record information about the vehicle’s performance and how it is driven. For example, the vehicle uses computer modules to monitor and control engine and transmission performance, to monitor the conditions for airbag deployment and deploy them in a cr ...

Side Blind Zone Alert (SBZA)
The vehicle may have a Side Blind Zone Alert (SBZA) system. Read this entire section before using the system. WARNING SBZA does not detect vehicles rapidly approaching outside of the side blind zones, pedestrians, bicyclists, or animals. Failure to use proper care when changing lanes may res ...

© 2017-2021 Copyright www.crion.site