Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the rear inner wheelhouse.

Note: Note the number and location of welds for installation of the service assembly.

  1. Drill all factory welds.

  1. Remove the rear inner wheelhouse.
Rear Wheelhouse Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing along the edges of the rear inner wheelhouse as noted from the original panel. Note: If the location of the original plug weld ...

Other materials:

Interior Care
To prevent dirt particle abrasions, regularly clean the vehicle's interior. Immediately remove any soils. Note that newspapers or dark garments that can transfer color to home furnishings can also permanently transfer color to the vehicle's interior. Use a soft bristle brush to remove ...

Front Fog Lamp Bulb Replacement
Preliminary Procedures Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle Disconnect the forward lamp electrical harness connector from the fog lamp bulb socket. Remove the Front Bumper Fascia Opening Lower Cover. Refer to Front Bumper Fascia Opening Lowe ...

Hood Primary and Secondary Latch Replacement
Preliminary Procedure Remove the front bumper fascia. Refer to Front  Bumper Fascia Replacement. Remove the radiator grille support reinforcement. Refer to Radiator Grille Reinforcement Support Replacement. Hood Primary and Secondary Latch Retainer Bolt (Qty: 2) Caution: ...

© 2017-2021 Copyright www.crion.site