Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the rear compartment floor panel.
  2. Note the number and location of weld studs for installation of the service assembly.
  3. Drill all factory welds.

  1. Remove the damaged rear compartment floor panel.
Rear Compartment Floor Panel Sectioning (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Align the rear compartment floor panel. Drill 4 mm (3/16 in) for rivets along the edges of the rear compartment floor were you cant apply a resistance spot welder. Clean and prepare ...

Other materials:

Center Pillar Upper Garnish Molding Replacement
Preliminary Procedure Remove the center pillar lower garnish molding. Refer to Center Pillar Lower Ga   rnish Molding Replacement Remove the seat belt from the front seat. Refer to Driver or Passenger Seat Retractor Side Belt Replacement Center Pillar Upper Garnish Mo ...

Installation Procedure
Create 8 x 14 mm (5/16 x 15/16 in) slots for MIG-Brazing along the edges of the drivetrain and front suspension frame front support as noted from the original panel. Clean and prepare the attaching  surfaces for brazing. Position the drivetrain and front suspension frame ...

SIR Service Precautions
SIR Service Precautions Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to observe the correct procedure could cause deployment of the SIR components. Serious injury can occur. Failure to observe the correct procedure ...

© 2017-2021 Copyright www.crion.site