Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the rear compartment floor panel.
  2. Note the number and location of weld studs for installation of the service assembly.
  3. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged rear compartment floor panel.
Rear Compartment Floor Panel Sectioning (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Align the rear compartment floor panel. Drill 8 mm (5/16 in) for plug welding along the edges of the rear compartment floor panel as noted from the original panel. Clean and prepare th ...

Other materials:

Navigation System
If the vehicle has a navigation system, there is a separate navigation manual that includes information on the radio, audio players, and navigation system. The navigation system provides detailed maps of most major freeways and roads. After a destination has been set, the system provides turn-b ...

Jump Starting
If the battery has run down, try to use another vehicle and some jumper cables to start your vehicle. Be sure to use the following steps to do it safely. WARNING   Batteries can hurt you. They can be dangerous because: • They contain acid that can burn you. • They contain gas ...

Driver Information Center (DIC)
The DIC display is in the center of the instrument cluster. It shows the status of many vehicle systems. The controls for the DIC are on the turn signal lever. 1. SET/CLR: Press to set, or press and hold to clear, the menu item displayed. 2. / : Use the thumbwheel to scroll through the it ...

© 2017-2021 Copyright www.crion.site