Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the body side outer panel reinforcement.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged body side outer panel reinforcement.
Body Side Outer Panel Reinforcement Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Align the body side outer panel reinforcement. Clean and prepare the attaching surfaces for welding. Position the body side outer panel   reinforcement on the vehicle. Verify ...

Other materials:

Ignition Positions (Key Access)
The ignition switch has four different positions. Notice: Using a tool to force the key to turn in the ignition could cause damage to the switch or break the key. Use the correct key, make sure it is all the way in, and turn it only with your hand. If the key cannot be turned by hand, see yo ...

Information Displays
Driver Information Center (DIC) The DIC displays information about your vehicle. It also displays warning messages if a system problem is detected. DIC Operation and Displays The DIC has different displays which can be accessed by using the DIC buttons on the turn signal lever. The DIC displ ...

Horns
Specifications Horn Replacement Preliminary Procedure Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Horn Nut Caution: Refer to Fastener Caution in the Preface section. Tighten 17 N·m (13 lb ft) Horn Tip Disconnect electrical connectors. St ...

© 2017-2021 Copyright www.crion.site