Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the rocker outer panel.

Note: Do not damage any inner panels or reinforcements.

Note: Do not damage any inner panels or reinforcements.

  1. Cut the panel where sectioning is to be performed.

  1. Locate and mark all the necessary factory welds of the rocker outer panel.
  2. Drill all factory welds.

  1. Remove the   damaged rocker outer panel.
Rocker Outer Panel Sectioning (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Cut the rocker outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickne ...

Other materials:

Exterior Lighting Systems Description and Operation
Exterior Lamps The exterior lighting system consists of the following lamps if equipped: Headlamps Daytime Running Lamps (DRL) Front fog lamps Rear fog lamps Park, tail and license lamps Turn signal lamps Hazard warning lamps Repeater lamps Stop lamps Backup lamps Low Beam ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted from the original panel. Clean and prepare the attaching surfaces for welding. Apply one-part windshield urethane adhesive as noted   from the original panel. Position the roof ...

Front Wheel Drive Shaft Replacement - Right Side
Special Tools CH-313 Slide Hammer CH-6003 Axle Shaft Remover CH-49376 Holding Wrench CH-49400 Hub Spindle Remover DT-6332 Seal Protector EN-956-1 Extension For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: To prevent personal injury and/or component ...

© 2017-2021 Copyright www.crion.site