Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair

  1. Create cut lines on the body lock pillar outer panel.

Note: Do not damage any inner panels or reinforcements.

Note: Do not damage any inner panels or reinforcements.

  1. Cut the panel where sectioning is to be performed.

  1. Locate and mark all the necessary factory welds of the body lock pillar outer panel.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged   body lock pillar outer panel.
Body Lock Pillar Outer Panel Sectioning (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Cut the body lock pillar outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the met ...

Other materials:

Front End Inflatable Restraint Discriminating Sensor Replacement
Warning: Refer to SIR Warning in the Preface section. Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary: The seat cushion frame The seat recliner, if equipped The seat adjuster The seat back frame ...

Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. There are only two reasons why the brake fluid level in the reservoir might go down: • The brake fluid level goes down because of normal brake lining wear. When new linings are in ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Batt ...

© 2017-2021 Copyright www.crion.site