Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the body side inner panel.

Note: Do not damage any inner panels or reinforcements.

Note: Do not damage any inner panels or reinforcements.

  1. Cut the panel where sectioning is to be performed.

  1. Locate and mark all the necessary factory welds of the body side inner panel.
  2. Drill all factory welds.

  1. Remove the body side inner panel.

  1. Locate and mark all the necessary factory welds of the rocker inner panel.
  2. Drill all factory welds.

  1. Remove the damaged rocker inner panel.
Rocker Inner Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Align the rocker inner panel. Clean and prepare the attaching surfaces for spot welding. Apply structural adhesive to all attaching surfaces. Position the rocker  inner panel on ...

Other materials:

Wheel Stud Replacement
Removal Procedure Raise and suitably support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Remove the wheel bearing/hub. Refer to Rear Wheel Bearing and Hub Replacement. Cauti ...

Relieving Fuel Pressure Warning
Warning: Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or ...

Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System (TPMS). The TPMS is designed to warn the driver when a low tire pressure condition exists. TPMS sensors are mounted onto each tire and wheel assembly, excluding the spare tire and wheel assembly. The TPMS sensors monitor the air pressure in t ...

© 2017-2021 Copyright www.crion.site