Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the body side inner panel.

Note: Do not damage any inner panels or reinforcements.

Note: Do not damage any inner panels or reinforcements.

  1. Cut the panel where sectioning is to be performed.

  1. Locate and mark all the necessary factory welds of the body side inner panel.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove  the body side inner panel.

  1. Locate and mark all the necessary factory welds of the rocker inner panel.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged rocker inner panel.
Rocker Inner Panel Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Align the rocker inner panel. Drill 8 mm (5/16 in) for plug welding along the edges of the quarter outer panel as noted  from the original panel. Clean and prepare the attaching ...

Other materials:

Vehicle Alarm System
This vehicle has a theft alarm system. Arming the System To arm the system, use the power door lock switch or the RKE transmitter to lock the vehicle while exiting with the vehicle turned off. The alarm arms after about 30 seconds after all the doors have been closed. Press again and the syst ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR   Disabling and Enabling. Disconnect the negative battery cable. Refer to ...

Exterior Care
Washing the Vehicle To preserve the vehicle's finish, wash it often and out of direct sunlight. Notice: Do not use petroleum-based, acidic, or abrasive cleaning agents as they can damage the vehicle's paint, metal, or plastic parts. If damage occurs, it would not be covered by the vehic ...

© 2017-2021 Copyright www.crion.site