Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the roof panel front bracket right (1).
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the roof panel front bracket right (1).
  2. Proceed the same way with the roof panel front bracket left.

  1. Create cut lines on the roof front header panel.

  1. Cut the panel where   sectioning is to be performed.

  1. Remove the damaged roof front header panel.
Roof Front Header Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Cut the roof front header panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal th ...

Other materials:

Service Vehicle Messages
SERVICE AC SYSTEM This message displays if there is a problem with the air conditioning system. Take the vehicle to your dealer for service. SERVICE POWER STEERING This message displays if there is a problem with the power steering system. Take the vehicle to your dealer for service. SERVICE ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR Disabling and Enabling. Disconnect the negative battery cable. Refer to Batter ...

Installation Procedure
Position the front end upper tie bar (1) on the vehicle. Verify the fit of the front end upper tie bar. Clamp the front end upper tie bar into position. Braze accordingly. Braze accordingly. Grind down weld seams as needed for related panels and components. Clean a ...

© 2017-2021 Copyright www.crion.site