Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the front hinge pillar body.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged front hinge pillar body reinforcement
Body Hinge Pillar Lower Reinforcement Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Prepare all mating surfaces as necessary. Align the front hinge pillar body reinforcement. Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing in locations where you can not app ...

Other materials:

Vehicle Load Limits
It is very important to know how much weight the vehicle can carry. This weight is called the vehicle capacity weight and includes the weight of all occupants, cargo, and all nonfactory-installed options. Two labels on the vehicle show how much weight it may properly carry: the Tire and Loadi ...

Remote Vehicle Start
The vehicle may have this feature that allows you to start the engine from outside the vehicle. (Remote Vehicle Start): This button will be on the RKE transmitter if the vehicle has remote start. The climate control system will use the previous settings during a remote start. The rear defog ...

Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Ensure that the steering wheel is set in a straight ahead position. Loosen the tie rod jam nut (1). Adjust the toe to specification by turning the adjuster (2). Refer to Wheel Alignment Specifications. Caution: Refer to Fastener Caution in the Preface section. Tighten the tie ro ...

© 2017-2021 Copyright www.crion.site