Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR  Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the front compartment front rail.

Note: Do not damage internal reinforcement of front compartment

Note: Do not damage internal reinforcement of front compartment side rail.

  1. Cut the panel where sectioning is to be performed.

Note: Left side only.

Note: Left side only.

  1. Locate and mark all the necessary factory welds of the front  compartment front rail.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged front compartment front rail.
Front Compartment Side Rail Sectioning (Short, MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Cut the front compartment front rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the met ...

Other materials:

Service Vehicle Messages
SERVICE AC SYSTEM This message displays if there is a problem with the air conditioning system. Take the vehicle to your dealer for service. SERVICE POWER STEERING This message displays if there is a problem with the power steering system. Take the vehicle to your dealer for service. SERVICE ...

Front Fog Lamp Replacement
Preliminary Procedures Raise and support the vehicle. Refer to Lifting   and Jacking the Vehicle. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Disconnect fog lamp bulb socket electrical connector. Front Fog Lamp Screws (Qty: 3) Caution: Refer t ...

Trademarks and License Agreements
FCC Information See “Radio Frequency Statement” in the owner manual for information regarding Part 15 of the Federal Communications Commission (FCC) rules and with Industry Canada Standards RSS-GEN/210/220/310. “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been ...

© 2017-2021 Copyright www.crion.site