Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR   Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds of the front wheelhouse panel rear reinforcement.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the front wheelhouse panel rear reinforcement.
Front Wheelhouse Panel Rear Reinforcement Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-Brazing along the edges of the front wheelhouse panel rear reinforcement as noted from the original panel. Create a 5 x 18 mm (4/ ...

Other materials:

Pretensioner Handling and Scrapping
Special Tools EL-38826 SIR Deployment Harness EL-39401-B SIR Deployment Fixture For equivalent regional tools, refer to Special Tools. Warning: When you are carrying an undeployed seat belt pretensioner: Do not carry the seat belt pretensioner by the wires or connector on the preten ...

Roof
Specifications Sunroof Schematics Sunroof Component Views   Sunroof Frame Sunroof Sunshade Sunroof Window Sunroof Window Seal Sunroof Housing Rear Drain Hose Sunroof Housing Drain Gutter Sunroof Frame Bolts Sunroof Window Guide Sunroof Air Deflector Cover Su ...

Windshield Wiper/Washer
The windshield wiper/washer lever is on the right side of the steering column. With the ignition in ACC/ ACCESSORY or ON/RUN, move the windshield wiper lever to select the wiper speed. HI: Use for fast wipes. LO: Use for slow wipes. INT: (Intermittent Wipes): Move the lever up to INT for ...

© 2017-2021 Copyright www.crion.site