Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR   Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Locate and mark all the necessary factory welds and weld seams of the drivetrain and front suspension frame front support.

  1. Drill out front flange of front suspension support frame from above through the front compartment side rail.

Note: Drill holes are necessary for later plug welds.

  1. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the drivetrain and front suspension frame front support.
Drivetrain and Front Suspension Frame Front Support Replacement (MAG-Welding)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the drivetrain and front suspension frame front support as noted from the original panel. Clean and prepare the attaching &n ...

Other materials:

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Drill 8 mm (5/16 in) for plug welding along the edges of the rear floor panel filler as noted  from the original panel. Clean and prepare the atta ...

Climate Control Systems
The heating, cooling, defrosting, and ventilation for the vehicle can be controlled with these systems. Vehicles without Air Conditioning   1. Temperature Control. 2. Bi-level Air Mode. 3. Floor Air Mode. 4. Vent Air Mode. 5. Fan Control. 6. Driver and Passenger Heated Seats (If Equ ...

Adding Equipment to the Airbag-Equipped Vehicle
Adding accessories that change the vehicle's frame, bumper system, height, front end, or side sheet metal, may keep the airbag system from working properly. The operation of the airbag system can also be affected by changing or moving any parts of the front seats, safety belts, the airbag ...

© 2017-2021 Copyright www.crion.site