Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Removal Procedure

Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning: Refer to Collision Sectioning Warning in the Preface section.

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  3. Remove all related panels and components.
  4. Visually inspect the damage. Repair as much of the damage as possible.
  5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

  1. Create cut lines on the front end upper tie bar.

  1. Cut the panel where sectioning is to be performed.

Note: Do not damage any inner panels or reinforcements.

  1. Locate and mark all the necessary factory welds of the front end upper tie bar.
  2. Drill all factory welds. Note the number and location of welds for installation of the service assembly.

  1. Remove the damaged front end upper tie bar.
Front End Upper Tie Bar Support Sectioning (MIG Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. ...

Installation Procedure
Cut the front end upper tie bar in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal th ...

Other materials:

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Bat ...

Installation Procedure
Create 5 x 18 mm (4/16 x 11/16 in) slots for MIG-brazing along the edges of the tail lamp pocket as noted f  rom the original panel. Note: Clean and prepare the attaching surfaces for brazing. Position the tail lamp pocket on the vehicle. Verify the fit of the ta ...

Filling a Portable Fuel Container
WARNING Filling a portable fuel container while it is in the vehicle can cause fuel vapors that can ignite either by static electricity or other means. You or others could be badly burned and the vehicle could be damaged. Always: • Use approved fuel containers. • Remove the container from the ...

© 2017-2021 Copyright www.crion.site