Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Wheelhouse Panel Replacement (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Rear Wheelhouse Panel Replacement (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Align the rear compartment floor panel. Drill 4 mm (3/16 in) for rivets along the edges of the rear compartment floor were you cant apply a resistance spot welder. Clean and prepare ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. ...

Other materials:

Steering Linkage Outer Tie Rod Replacement
Preliminary Procedure Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation. Steering Linkage Tie Rod Nut Caution: Refer to Fastener Caution in the Preface section. Tighten 35 N·m (26 lb ft) Steering Linkage Inner Tie Rod Nut Tighten 60 N·m (44 ...

Front Side Door Trim Replacement
Front Side Door Pull Handle Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 2 N·m (18 lb in) Front Side Door Inside Handle Bolt Finish Cap Tip Pull handle back to remove cap. Use suitable tool to unsnap. Front Side Door Inside Handle Bolt Tighten ...

Tail Lamp Replacement
Preliminary Procedures Open and support   the rear compartment lid. Remove the body side trim panel replacement in order to expose the tail lamp pocket nuts. Refer to Body Side Trim Panel Replacement - Left Side. Tail Lamp Bolt (Qty: 2) Caution: Refer to Fastener Caut ...

© 2017-2021 Copyright www.crion.site