Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Side Door Wiring Harness Replacement

Preliminary Procedure

Preliminary Procedure

Remove the rear side door inner panel trim. Refer to Rear Side Door Trim Replacement.

  1. Rear Side Door Wiring Harness

Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

For Vehicles equipped with OnStar® (UE1) with Back Up Battery: The Back Up Battery is a redundant power supply to allow limited OnStar® functionality in the event of a main vehicle battery power disruption to the VCIM (OnStar®module). Do not disconnect the main vehicle battery or remove the OnStar® fuse with the ignition key in any position other than OFF. Retained accessory power (RAP) should be allowed to time out or be disabled (simply opening the driver door should disable RAP) before disconnecting power. Disconnecting power to the OnStar® module in any way while the ignition is On or with RAP activated may cause activation of the OnStar® Back-Up Battery (BUB) system and will discharge and permanently damage the back-up battery. Once the Back-Up Battery is activated it will stay on until it has completely discharged. The BUB is not rechargeable and once activated the BUB must be replaced.

Procedure

  1. Disconnect the battery.
  2. Remove the water deflector.
  3. Disconnect electrical connectors as needed.
Front Side Door Wiring Harness Replacement
Preliminary Procedure Remove the front side door inner panel trim. Refer to Front Side Door Trim Replacement. Front Side Door Wiring Harness Warning: Unless directed otherwise, the ignition a ...

Hood Primary Latch Release Cable Handle Replacement
Preliminary Procedure Remove the front side door sill trim plate. Refer to Front Side Door Sill Trim Plate Replacement. Hood Primary Latch Release Cable Handle Procedure Pull down the hoo ...

Other materials:

Malfunction Indicator Lamp
A computer system called OBD II (On-Board Diagnostics-Second Generation) monitors the operation of the vehicle to ensure emissions are at acceptable levels, helping to maintain a clean environment. The malfunction indicator lamp comes on when the vehicle is placed in ON/RUN for key access or ...

Satellite Radio
SiriusXM® Satellite Radio Vehicles with a valid SiriusXM satellite radio subscription can receive SiriusXM programming. SiriusXM satellite radio has a wide variety of programming and commercial-free music, coast to coast, and in digital-quality sound. See www.siriusxm.com or call 1-866-635- ...

Filling the Tank
WARNING Fuel vapors and fuel fires burn violently and can cause injury or death. • To help avoid injuries to you and others, read and follow all the instructions on the fuel pump island. • Turn off the engine when refueling. • Keep sparks, flames, and smoking materials away from fuel. • Do no ...

© 2017-2021 Copyright www.crion.site