Chevrolet Cruze Repair Manual: Rear Side Door Trim Replacement
- Rear Side Door Inside Handle Bolt Finish Cap
Procedure
Pull handle back to remove cap. Use suitable tool to unsnap.
- Rear Side Door Inside Handle Screw
Caution: Refer to Fastener Caution in the Preface section.
Tighten 2.5 N·m (23 lb in)
- Rear Side Door Pull Handle Screw
Tighten 2.5 N·m (23 lb in)
- Rear Side Door Trim Clip (Qty: 5)
- Rear Side Door Trim Assembly
Procedure
- Pull upwards on the door lock retainer cable to disengage.
- Disconnect the electrical connectors.
Rear Compartment Sill Trim Plate Replacement
- Rear Compartment Lid Latch Striker Cover
- Rear Compartment Sill Trim Plate Clip (Qty: 4)
- Rear Compartment Sill Trim Plate Assembly
Rear Compartment Lid Inner Panel Trim Replacement
- Rear Compartment Lid Inner Panel Trim Retainer (Qty: 12)
- Rear Compartment Lid Inner Panel Trim Assembly
Rear Compartment Side Trim Replacement - Left Side
Preliminary Procedures
Remove rear compartment sill trim plate. Refer to Rear Compartment Sill Trim Plate Replacement
- Body Side Trim Panel Retainer (Qty: 3)
- Body Side Trim Panel Screw
- Body Side Trim Panel Assembly
Rear Compartment Side Trim Replacement - Right Side
Preliminary Procedure
Remove rear compartment sill trim plate. Refer to Rear Compartment Sill Trim Plate Replacement
- Body Side Trim Panel Retainer (Qty: 4)
- Body Side Trim Panel Assembly
Special Tools and Equipment
Body Side Trim Panel Replacement - Left Side
Preliminary Procedure
Remove the rear side door sill trim plate. Refer to Rear Side Door Sill
Trim Plate Replacement.
Remove the rear seat back. Refer to Rear Seat Replacement.
Re ...
Body repair
...
Other materials:
Removal Procedure
Remove the drivetrain and front suspension frame. Refer to Drivetrain
and Front Suspension Frame Replacement.
Mark Installation position of insulator (2) at frame (1).
Cut out frame insulator core (1) from frame insulator (2).
Note: On the rear insulator dril ...
Dual Stage Inflator Modules
Dual stage inflator modules contain a housing, inflatable air bag, two
initiating devices, canister of gas generating material and, in some
cases, stored compressed gas. The two initiators are part of the frontal
deployment loop. The function of the frontal deployment loops are
to supply curre ...
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the
Preface section.
Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.
Disable the SIR System. Refer to SIR
Disabling and Enabling.
Disconnect the negative battery cable. Refer to ...