Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Side Door Replacement

Preliminary Procedure

Preliminary Procedure

  1. Remove the rear side door trim panel. Refer to Rear Side Door Trim Replacement.

Rear Side Door Check Link Bolt Caution: Refer to Fastener Caution in the Preface section.

Procedure

  1. Remove the water deflector
  2. Disconnect the door electrical connector.
  3. Support the door before removing the hinge bolts
  4. With the aid of an assistant, remove the door.

Tighten 25 N·m (18 lb ft)

  1. Rear Side Door Lower Hinge Bolt (Qty: 2)

Tighten 25 N·m (18 lb ft)

  1. Rear Side Door Upper Hinge Bolt (Qty: 2)

Tighten 25 N·m (18 lb ft)

  1. Rear Side Door

Procedure

  1. Transfer all of the internal components.
  2. Adjust the rear side door as needed. Refer to Rear Side Door Adjustment.
Rear Side Door Adjustment
Rear Side Door Caution: Refer to Fastener Caution in the Preface section. Procedure Loosen the rear door hinge bolt (Qty: 4)  to adjust the rear door. Adjust the rear door in order to ...

Front Fender Replacement
Preliminary Procedure Remove the front bumper fascia. Refer to Front  Bumper Fascia Replacement Remove front bumper fascia guide. Refer to Front Bumper Fascia Replacement Remove ...

Other materials:

Rear Compartment Lid Weatherstrip Replacement
Rear Compartment Lid Weatherstrip Procedure Start at the upper corner of the rear compartment opening and pull the weatherstrip away from the rear compartment opening flange. Position the weatherstrip in the upper corner of the r 2. ear compartment opening. Working downward alon ...

Steering Linkage Inner Tie Rod Replacement (Hydraulic Power Steering)
Special Tools CH-6247 Removal and Installation Tool for the Steering Linkage Inner Tie Rod For equivalent regional tools, refer to Special Tools. Removal Procedure Raise and support the vehicle. Refer to Lifting  and Jacking the Vehicle. Remove the tire and wheel assembly. Refer to ...

SIR Service Precautions
SIR Service Precautions Warning: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Failure to observe the correct procedure could cause deployment of the SIR components. Serious injury can occur. Failure to observe the correct procedure ...

© 2017-2021 Copyright www.crion.site