Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Side Door Outside Handle Rod Adjustment

Chevrolet Cruze Repair Manual / Body systems / Vehicle Access / Rear Side Door Outside Handle Rod Adjustment

Removal Procedure

  1. Remove the rear door water deflector as needed. Refer to Rear Side Door Water Deflector Replacement.
  2. Use a flat-head tool to open the clip from the threaded rod connecting the lock to the outside handle.
  3. Adjust the travel of the handle by removing the threaded rod from the clip.

Installation Procedure

  1. Position the outside door handle rod (2) in the clip (1) in order to eliminate any free play in the outside door handle.
  2. Install the clip cover closed over the threaded outside door handle rod.
  3. Inspect the door lock system for proper operation.
  4. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement.

Rear Compartment Lid Latch Striker Replacement

Preliminary Procedure

Preliminary Procedure

Remove the rear compartment sill trim plate. Refer to Rear Compartment Sill Trim Plate Replacement.

  1. Rear Compartment Lid Latch Striker Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Use a grease pencil to outline the striker before removing the bolts.

Tighten 9 N·m (80 lb in)

  1. Rear Compartment Lid Latch Striker

Tip

Adjust the rear compartment lid latch striker after replacing, if needed.

Door Lock Switch Replacement

  1. Door Lock Switch Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 1.5 N·m (13 lb in)

  1. Door Lock Switch

Tip

Disconnect electrical connector.

Vehicle Access
Specifications Door Lock/Indicator Schematics Door Control Module Schematics Release Systems Schematics Fuel Tank Filler Door Lock Actuator Replacement ...

Door Ajar Indicator Description and Operation
Door Ajar Indicator System Components The door ajar indicator system consists of the following components: Body control module (BCM) Instrument cluster Driver information center Driver door ...

Other materials:

Recreational Vehicle Towing
Recreational vehicle towing refers to towing the vehicle behind another vehicle – such as behind a motor home. The two most common types of recreational vehicle towing are known as dinghy towing and dolly towing. Dinghy towing is towing the vehicle with all four wheels on the ground. Dolly tow ...

Rear Compartment Lid Emblem/Nameplate Replacement (Rear Emblem)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to deve ...

Installation Procedure
Cut the front compartment front rail in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused porti ...

© 2017-2021 Copyright www.crion.site