Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Compartment Lid Weatherstrip Replacement

Chevrolet Cruze Repair Manual / Body repair / Bolted Exterior Body Panels and Closures / Rear Compartment Lid Weatherstrip Replacement

Rear Compartment Lid Weatherstrip

Rear Compartment Lid Weatherstrip

Procedure

  1. Start at the upper corner of the rear compartment opening and pull the weatherstrip away from the rear compartment opening flange.
  2. Position the weatherstrip in the upper corner of the r 2. ear compartment opening.
  3. Working downward along the edge, install the weatherstrip on the rear compartment opening flange ensuring that the carrier is fully seated in the corners.
  4. Using a rubber mallet, ensure that the weatherstrip is seated on the entire trunk opening flange.
Front Side Door Weatherstrip Replacement - Body Side
Front Side Door Weatherstrip - Body Side Procedure Start at the rear upper corner of the door opening and pull the weatherstrip away from   the door opening flange. Position th ...

Rear Side Door Weatherstrip Replacement - Door Side
Rear Side Door Check Bolt Caution: Refer to Fastener Caution in the Preface section. Tighten 25 N·m (19 lb ft) Rear Side Door Weatherstrip - Door Side Procedure Unclip weather ...

Other materials:

Installation Procedure
Cut the body lock pillar outer panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint Create a 50 mm (2 in) backing plate from the unused portio ...

Pretensioner Handling and Scrapping
Special Tools EL-38826 SIR Deployment Harness EL-39401-B SIR Deployment Fixture For equivalent regional tools, refer to Special Tools. Warning: When you are carrying an undeployed seat belt pretensioner: Do not carry the seat belt pretensioner by the wires or connector on the preten ...

Adding Equipment to the Airbag-Equipped Vehicle
Adding accessories that change the vehicle's frame, bumper system, height, front end, or side sheet metal, may keep the airbag system from working properly. The operation of the airbag system can also be affected by changing or moving any parts of the front seats, safety belts, the airbag ...

© 2017-2021 Copyright www.crion.site