Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Compartment Lid Emblem/Nameplate Replacement (VCDi)

Chevrolet Cruze Repair Manual / Body hardware and trim / Exterior Trim / Rear Compartment Lid Emblem/Nameplate Replacement (VCDi)

Rear Compartment Lid Emblem Assembly

Rear Compartment Lid Emblem Assembly

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Procedure

  1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
  2. Use a Heat Gun or equivalent to remove the old emblem. Clean all adhesive from the rear compartment panel and wipe the surface dry with a clean lint-free towel prior to installing the new emblem.
  3. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
  4. Close the rear compartment  lid prior to adhesion.
  5. Using the palm of the hand, wet out the emblem to the rear compartment lid to ensure full adhesion of the emblem is made.
Rear Compartment Lid Emblem/Nameplate Replacement (LT or LTZ)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installati ...

Rear Compartment Lid Emblem/Nameplate Replacement (VCDi AT)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installati ...

Other materials:

StabiliTrak® System
The vehicle has a vehicle stability enhancement system called StabiliTrak. It is an advanced computer controlled system that assists with directional control of the vehicle in difficult driving conditions. StabiliTrak activates when the computer senses a difference between the intended path, ...

Installation Procedure
Apply structural adhesive on the flanges of the rear side door inner panel where the rear side door outer panel bears on. Align the rear side door outer panel. Verify the fit of the rear side door outer panel. Clamp the rear side door outer  panel into position. Pre-fla ...

Ultra High Strength Dual Phase Steel
This information provides repair recommendations and general guidelines for steel classified as Ultra High Strength Dual Phase Steel (Dual Phase Steel with a tensile strength greater than 800 MPa), also known as DPX. General Motors recommends the following when repairing or replacing this type ...

© 2017-2021 Copyright www.crion.site