Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Compartment Lid Emblem/Nameplate Replacement (LT or LTZ)

Chevrolet Cruze Repair Manual / Body hardware and trim / Exterior Trim / Rear Compartment Lid Emblem/Nameplate Replacement (LT or LTZ)

Rear Compartment Lid Emblem Assembly

Rear Compartment Lid Emblem Assembly

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Procedure

  1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
  2. Use a Heat Gun or equivalent to remove the old emblem. Clean all adhesive from the rear compartment panel and wipe the surface dry with a clean lint-free towel prior to installing the new emblem.
  3. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
  4. Close the rear compartment  lid prior to adhesion.
  5. Using the palm of the hand, wet out the emblem to the rear compartment lid to ensure full adhesion of the emblem is made.
Rear Compartment Lid Emblem/Nameplate Replacement (Rear Emblem)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installati ...

Rear Compartment Lid Emblem/Nameplate Replacement (VCDi)
Rear Compartment Lid Emblem Assembly Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section. Procedure The part and surface should be 21°C (70°F) prior to installati ...

Other materials:

Installation Procedure
Remove all mounds or loose pieces of urethane adhesive from the pinch-weld area. Inspect for any of the following problems in order to help prevent future breakage of the window: High weld Solder spots Hardened sealer Any other obstruction or irregularity in the pinch-weld fla ...

Buying New Tires
GM has developed and matched specific tires for the vehicle. The original equipment tires installed were designed to meet General Motors Tire Performance Criteria Specification (TPC Spec) system rating. When replacement tires are needed, GM strongly recommends buying tires with the same TPC Sp ...

Air Conditioning Compressor and Condenser Hose Replacement (1.6L LXT)
Removal Procedure Recover the refrigerant. Refer to Refrigerant Rec   overy and Recharging. Remove front bumper fascia. Refer to Front Bumper Fascia Replacement. Remove A/C compressor and condenser hose nut (1) from A/C condensor (2). Remove A/C compressor and ...

© 2017-2021 Copyright www.crion.site