Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Compartment Floor Panel Sectioning (MAG-Welding)

Chevrolet Cruze Repair Manual / Body repair / Collision Repair / Rear Compartment Floor Panel Sectioning (MAG-Welding)

Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Installation Procedure
Clean and prepare the attaching surfaces for welding. Apply structural adhesive to the attaching flanges. Position the body side outer lower panel on the vehicle Verify the fit of the ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR Syst ...

Other materials:

Where Are the Airbags?
The driver frontal airbag is in the center of the steering wheel. The front outboard passenger frontal airbag is in the passenger side instrument panel. The driver knee airbag is below the steering column. The front outboard passenger knee airbag is below the glove box. Driver Side Show ...

Adding Equipment to the Airbag-Equipped Vehicle
Adding accessories that change the vehicle's frame, bumper system, height, front end, or side sheet metal, may keep the airbag system from working properly. The operation of the airbag system can also be affected by changing or moving any parts of the front seats, safety belts, the airbag ...

Installation Procedure
Cut the roof front header panel in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint. Create a 50 mm (2 in) backing plate from the unused portion of ...

© 2017-2021 Copyright www.crion.site