Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Bumper Impact Bar Replacement

Chevrolet Cruze Repair Manual / Body repair / Rear Bumper Impact Bar Replacement

Preliminary Procedure

Preliminary Procedure

Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement.

  1. Rear Bumper Energy Absorber Nut (Qty: 6)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 40 N·m (30 lb ft)

  1. Rear Bumper Impact Bar

Special Tools and Equipment

Collision Repair

Rear Bumper Fascia Outer Guide Replacement
Preliminary Procedure Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement. Rear Bumper Fascia Outer Guide Rivet (Qty: 3) Special Tools BO-594-A Hand Rivet Tongs For eq ...

Collision Repair
Specifications Point-to-point measurements are for reference only. All measurements are given in millimeters. Use these measurements for diagnosing and estimating. Point-to-point measurements ...

Other materials:

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the service panel as noted from the original panel. Clean and prepare the attaching surfaces for welding. Position the roof rear header (1) panel on the vehicle. Verify the fit of the panel. Clamp the roof rear header ...

Installation Procedure
Drill 8 mm (5/16 in) for plug welding along the edges of the drivetrain and front suspension frame front support as noted from the original panel. Clean and prepare the attaching   surfaces for welding. Position the drivetrain and front suspension frame front suppor ...

Tire Pressure Monitor Operation
This vehicle may have a Tire Pressure Monitor System (TPMS). The TPMS is designed to warn the driver when a low tire pressure condition exists. TPMS sensors are mounted onto each tire and wheel assembly, excluding the spare tire and wheel assembly. The TPMS sensors monitor the air pressure in t ...

© 2017-2021 Copyright www.crion.site