Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Rear Bumper Fascia Replacement

Chevrolet Cruze Repair Manual / Body repair / Rear Bumper Fascia Replacement

Preliminary Procedure

Preliminary Procedure

Remove the tail lamps. Refer to Tail Lamp Replacement.

  1. Rear Bumper Fascia Retainer (Qty: 2)
  2. Rear Wheelhouse Liner Bolt (Qty: 6) Caution: Refer to Fastener Caution in the Preface section.

Tighten 2.5 N·m (23 lb in)

  1. Rear Bumper Fascia

Procedure

  1. Pull the rear bumper fascia rearwards at the front edge to load the three clips on the inboard fascia guides (under the tail lamp position)
  2. Release the   clips with an suitable tool
  3. Continue to pull the rear bumper fascia rearwards until the outer edges pop outboard.
  4. Disconnect any electrical connectors as needed
  5. Remove the rear bumper fascia.
  6. Transfer parts as needed.
Front Bumper Fascia Guide Replacement
Preliminary Procedure Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement. Front Bumper Fascia Guide Rivet (Qty: 2) Headlamp Bolt Caution: Refer to Fastener Caution ...

Rear Bumper Fascia Guide Replacement
Preliminary Procedure Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement. Rear Bumper Fascia Guide Rivet (Qty: 4) Special Tools BO-594-A Hand Rivet Tongs For equivale ...

Other materials:

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection. Remove all related panels and ...

Rear Spring Insulator Replacement
Removal Procedure Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle. Support the rear axle with a tall jack stand near the shock absorber. Remove the lower shock bolt. Refer to Shock Absorber Replacement. Using the tall jack stands, slowly lower the rear a ...

Securing Child Restraints (Rear Seat)
When securing a child restraint in a rear seating position, study the instructions that came with the child restraint to make sure it is compatible with this vehicle. If the child restraint has the LATCH system. Do not secure a child seat in a position without a top tether anchor if a national ...

© 2017-2022 Copyright www.crion.site