Chevrolet Cruze manuals

Chevrolet Cruze Infotainment System: Radio Reception

Frequency interference and static can occur during normal radio reception if items such as cell phone chargers, vehicle convenience accessories, and external electronic devices are plugged into the accessory power outlet. If there is interference or static, unplug the item from the accessory power outlet.

FM

FM signals only reach about 16 to 65 km (10 to 40 mi). Although the radio has a built-in electronic circuit that automatically works to reduce interference, some static can occur, especially around tall buildings or hills, causing the sound to fade in and out.

AM

The range for most AM stations is greater than for FM, especially at night. The longer range can cause station frequencies to interfere with each other. Static can occur when things like storms and power lines interfere with radio reception. When this happens, try reducing the treble on the radio.

SiriusXM® Satellite Radio Service

SiriusXM Satellite Radio Service gives digital radio reception from coast to coast in the 48 contiguous United States, and in Canada. Just as with FM, tall buildings or hills can interfere with satellite radio signals, causing the sound to fade in and out. In addition, traveling or standing under heavy foliage, bridges, garages, or tunnels may cause loss of the SiriusXM signal for a period of time.

Cellular Phone Usage

Cellular phone usage can cause interference with the vehicle's radio.

Satellite Radio
SiriusXM® Satellite Radio Vehicles with a valid SiriusXM satellite radio subscription can receive SiriusXM programming. SiriusXM satellite radio has a wide variety of programming and commercial- ...

Quick Info
Quick Info gives access to quick information on Audio playing, OnStar Turn-by-Turn route (if equipped), 5-day forecast, Nearby Fuel Stations, and Movie Show Times. To access, press Quick Info on ...

Other materials:

Installation Procedure
Remove the front wheelhouse rear panel brace (1) from service panel. Create 6 x 20 mm (4/16 x 12/16 in) slots for MIG-brazing along the edges of the front wheelhouse (1). Clean and prepare the attaching surfaces for brazing. Note: In MIG-brazing areas 50 mm (2 in) must b ...

Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. There are only two reasons why the brake fluid level in the reservoir might go down: • The brake fluid level goes down because of normal brake lining wear. When new linings are in ...

Rear Bumper Fascia Guide Replacement
Preliminary Procedure Remove the rear bumper fascia. Refer to Rear Bumper Fascia Replacement. Rear Bumper Fascia Guide Rivet (Qty: 4) Special Tools BO-594-A Hand Rivet Tongs For equivalent regional tools, refer to Special Tools. Rear Bumper Fascia Guide Rear Bumper Fascia Inner ...

© 2017-2021 Copyright www.crion.site