Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Power Steering Pump Belt Replacement

Chevrolet Cruze Repair Manual / Additional links / Power Steering Pump Belt Replacement

Special Tools

CH 49800 Installer Power Steering Pump Belt

For equivalent regional tools, refer to Special Tools.

Removal Procedure

Caution: Do not use belt dressing on the drive belt. Belt dressing causes the breakdown of the composition of the drive belt. Failure to follow this recommendation will damage the drive belt.

  1. Open the hood

  1. Cut the power steering pump belt (2) with a appropriate cutting tool at position (1).
  2. Remove the power steering pump belt (2)

Installation Procedure

  1. Relieve the tension of the drive belt (1). Refer to Drive Belt Replacement.
  2. Install CH-49800 installer (3) on the power steering pump pulley.
  3. Install NEW power steering belt (2) aligning pulley water pump.
  4. Rotate the power steering pump pulley clockwise using hex wrench on the shaft power steering pump pulley.
  5. Remove the CH-49800 installer (3).
  6. Check the belt is installed clearly.
  7. Install the drive belt. Refer to Drive Belt Installation
  8. Close the hood.
Exhaust Flexible Pipe Replacement (1.6L LXT)
Removal Procedure Warning: Refer to Hot Exhaust System Warning in the Preface section. Warning: Refer to Protective Goggles and Glove Warning in the Preface section. Open the hood. Raise the ...

Front Brake Rotor Replacement
Special Tools CH-41013 Rotor Resurfacing Kit CH-42450-A Wheel Hub Resurfacing Kit For equivalent regional tools, refer to Special Tools. Removal Procedure Warning: Refer to Brake Dust Warni ...

Other materials:

Fuel
Use of the recommended fuel is an important part of the proper maintenance of this vehicle. To help keep the engine clean and maintain optimum vehicle performance, we recommend the use of gasoline advertised as TOP TIER Detergent Gasoline. Look for the TOP TIER label on the fuel pump to ensure ...

Automatic Dimming Rearview Mirror
To adjust the inside rearview mirror, hold the rearview mirror in the center and move it to view the area behind the vehicle. For vehicles with an automatic dimming rearview mirror, the mirror will automatically reduce the glare from the headlamps from behind. The dimming feature and the indic ...

Heated Seats
If available, the controls are on the center stack. The engine must be running to operate the heated seats. Press or to heat the driver or passenger seat cushion and seatback. Press the control once for the highest setting. With each press of the control, the heated seat will change to ...

© 2017-2021 Copyright www.crion.site