Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Power Steering

Specifications

Power Steering System Bleeding

Power Steering System Bleeding

Note:

Note:

Note: Power steering fluid level must be maintained throughout bleed procedure.

  1. Fill pump reservoir with fluid to minimum system level, FULL COLD level, or middle of hash mark on cap stick  fluid level indicator.

Note: With hydro-boost only, the oil level will appear falsely high if the hydro-boost accumulator is not fully charged. Do not apply the brake pedal with the engine OFF. This will discharge the hydro-boost accumulator.

  1. If equipped with hydro-boost, fully charge the hydro-boost accumulator using the following procedure:

2.1. Start the engine.

2.2. Firmly apply the brake pedal 10-15 times.

2.3. Turn the engine OFF.

  1. Raise the vehicle until the front wheels are off the ground. Refer to Lifting and Jacking the Vehicle.
  2. Key on engine OFF, turn the steering wheel from stop to stop 12 times.

Note: Vehicles equipped with hydro-boost systems or longer length power steering hoses may require turns up to 15 to 20 stop to stops.

  1. Verify power steering fluid level per operating specification. Refer to Checking and Adding Power Steering Fluid.
  2. Start the engine. Rotate steering wheel from left to right. Check for sign of cavitation or fluid aeration (pump noise/whining).
  3. Verify the fluid level. Repeat the bleed procedure, if necessary.
Steering
...

Checking and Adding Power Steering Fluid
Caution: When adding fluid or making a complete fluid change, always use the proper power steering fluid. Failure to use the proper fluid will cause hose and seal damage and fluid leaks. Clean ...

Other materials:

Courtesy Transportation Program
To enhance your ownership experience, we and our participating dealers are proud to offer Courtesy Transportation, a customer support program for vehicles with the Bumper-to-Bumper (Base Warranty Coverage period in Canada), extended powertrain, and/or hybrid-specific warranties in both the U.S ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Dis ...

Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR  Disabling and Enabling. Disconnect the negative battery cable. Refer to Bat ...

© 2017-2021 Copyright www.crion.site