Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Power Door Locks Description and Operation

Chevrolet Cruze Repair Manual / Body systems / Vehicle Access / Power Door Locks Description and Operation

Door Lock System Components

The power door lock system consists of the following components:

Door Lock System Controls

The power door lock system can be controlled by any of the following:

Door Lock and Unlock Operation

When a door lock switch is activated in the lock or unlock position the BCM will receive a ground signal on either the door lock switch lock or unlock signal circuits.

The BCM, upon receipt of a lock switch lock or unlock signal, will supply battery voltage to the door lock actuator lock or unlock control circuits. Since the opposite side of the lock actuator is connected to ground through the other lock actuator control circuit, the doors, fuel filler door and liftgate will then lock or unlock as commanded.

The following three circuits are used to operate the lock:

The driver door lock actuator is isolated so it can be unlocked by itself using the keyless entry transmitter.

Automatic Door Lock Operation

This feature can be personalized to driver preference.

The BCM will automatically lock the vehicle doors if the following conditions exist:

The BCM will then unlock the doors when vehicle is shifted back into Park.

Delayed Locking Operation

With any door open and a door lock switch is activated in the lock position, the BCM will give three audible chimes. When the door is closed, the BCM will cycle the internal door lock relay to lock the doors after approximately five seconds. This feature can be overridden by activating the door lock switch a second time and the doors will lock even with a door open.

Lockout Prevention Operation

The BCM will lock all doors and unlock the driver door with a door lock switch lock activation if a vehicle door is open and the ignition key is fully inserted in the ignition. The lockout prevention feature can be overridden if a lock command is received from the keyless entry system.

Special Tools and Equipment

Wipers and Washers

Power Door Latch Description and Operation
Power Door Latch System Components The power door latch system consists of the following components: Remote control door lock receiver Body control module (BCM) Driver door latch Passenger ...

Wipers and Washers
Specifications Wiper/Washer Schematics Windshield Wiper and Washer Switch Replacement Preliminary Procedure Remove the steering column trim covers. Refer to Steering Column Low ...

Other materials:

Floor Mats
WARNING If a floor mat is the wrong size or is not properly installed, it can interfere with the pedals. Interference with the pedals can cause unintended acceleration and/or increased stopping distance which can cause a crash and injury. Make sure the floor mat does not interfere with the p ...

Headlamp Mount Panel Replacement (MIG-Brazing)
Note: According to different corrosion warranties, only the regional mandatory joining methods are allowed. Removal Procedure Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface sec ...

Bluetooth (Infotainment Controls)
For information about how to navigate the menu system using the infotainment controls. Pairing A Bluetooth-enabled cell phone must be paired to the Bluetooth system and then connected to the vehicle before it can be used. See your cell phone manufacturer's user guide for Bluetooth functi ...

© 2017-2021 Copyright www.crion.site