Chevrolet Cruze manuals

Chevrolet Cruze Infotainment System: Pictures

Pictures can only be viewed using USB devices. If pictures are on an SD card, transfer to a USB device or use a USB-SD adapter. File sizes above approximately four mega pixels may not show. Only jpeg, bmp, gif, and png files are supported.

1. Press the Pictures screen button on the Home Page.

2. The system does a search to find the picture folders.

A “Please wait” message displays until the search is finished.

3. A list displays. Select a picture to view.

3. A list displays. Select a picture to view.

4. Once a picture displays, the following options are available: Info:

4. Once a picture displays, the following options are available: Info

: Press to turn file name information on or off.

if not in slide show mode. : Press to display a previous picture if not in slide show mode.

mode and manual mode. : Press to toggle between slide show mode and manual mode.

if not in slide show mode.: Press to display a next picture if not in slide show mode.

90 degrees counterclockwise. : Press to manually rotate a picture 90 degrees counterclockwise.

Menu

: Press to open the Picture Viewer Settings screen. Slide Picture Viewer Main, Slideshow Timer, and Shuffle Images display as options for configuring the view of images stored in the system.

If the displayed picture screen is not used within six seconds, the upper and lower bar options will disappear.

Touch-tap the screen to re-display the upper and lower bar.

Stitcher Internet Radio
Stitcher SmartRadio™ is an Internet radio service that streams news, sports, and entertainment shows through the audio system. Create personalized, on-demand stations or discover new shows through ...

Audio Players
...

Other materials:

Brake Pedal Position Sensor Calibration
Calibration Criteria Note: Do not apply the brake pedal during the brake pedal position (BPP) sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the sensor calibration must be repeated. Brake pedal ...

Installation Procedure
Note: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1½ in). Drill 8 mm (5/16 in) for plug welding along the edges of the body rear end panel as noted  from the original panel. Clean and prepare the attaching s ...

Front Side Door Replacement
Preliminary Procedure Remove the front side door trim panel. Refer to Front Side Door Trim Replacement. Front Side Door Check Link Bolt Caution: Refer to Fastener Caution in the Preface section. Procedure Remove the water deflector. Disconnect the door electrical connector. Su ...

© 2017-2021 Copyright www.crion.site