Chevrolet Cruze Repair Manual: Mild Steel
This information provides repair recommendations and general guidelines for steel classified as Mild Steel. This type of steel normally has a tensile strength less than 270 MPa. This includes the common steel names of:
- Mild Steel
- Bake Hardenable Steel (BH)
- Solid Solution Strengthened Steel
General Motors recommends the following when repairing or replacing this type of steel during collision repair.
Recommended Repairs:
- Cold repairs can be performed on this type of steel, unless the damage includes kinks. If the damage includes kinks, the part should be replaced.
- Controlled use of heat can be used to repair damage, if the heat does not exceed 650°C (1200°F). The heat should be applied a maximum of 2 times, for up to 90 seconds.
- Sectioning or partial replacement of this type of steel is recommended only at approved locations, in a specific sectioning procedure.
- This type of steel can be used as a sleeve, or backer plate, when recommended in a specific sectioning procedure.
- Squeeze Resistance Spot Welding can be used to replace factory spot welds, where applicable
- MIG plug welding and MIG stitch welding can be used on this type of steel.
- MIG Brazing can be used on this type of steel
High Strength Low Alloy Steel
This information provides repair recommendations and general guidelines for
steel classified as High Strength Low Alloy Steel, also known
as HSLA. This type of steel normally has a tensile strength ...
Ultra High Strength Dual Phase Steel
This information provides repair recommendations and general guidelines for
steel classified as Ultra High Strength Dual Phase Steel (Dual
Phase Steel with a tensile strength greater than 800 MPa), ...
Other materials:
Rear Side Door Window Replacement
Preliminary Procedures
Position the window approximately half way down in the door.
Remove the water deflector. Refer to Rear Side Door Water Deflector
Replacement.
Remove the outer sealing strip. Refer to Rear Side Door Window Outer
Sealing Strip Replacement.
Rear Side ...
Distracted Driving
Distraction comes in many forms and can take your focus from the task of driving.
Exercise good judgment and do not let other activities divert your attention away
from the road. Many local governments have enacted laws regarding driver distraction.
Become familiar with the local laws in your ...
Hood Primary Latch Release Cable Handle Replacement
Preliminary Procedure
Remove the front side door sill trim plate. Refer to Front Side Door Sill
Trim Plate Replacement.
Hood Primary Latch Release Cable Handle
Procedure
Pull down the hood primary latch release cable handle.
To release the handle, pull down the cable and unhook ...