Rear Compartment Lid Release System Components
Rear Compartment Lid Release Operation
When the exterior rear compartment lid release switch is pressed, the trunk release switch signal circuit is switched to ground. The BCM responds by applying battery voltage to the trunk release relay control circuit which energizes the rear compartment lid release relay. The rear compartment lid release relay is supplied with battery voltage at all times from an instrument panel fuse. With the relay coil energized, the relay switch contacts close allowing battery voltage to flow to the rear compartment lid release actuator causing the rear compartment lid to release. The exterior rear compartment lid release switch is permanently grounded to a fixed body ground.
When accessing the rear compartment using the key fob, a valid keyless entry transmitter is required to be within a 30 meter range of the vehicle. This allows the required keyless access communications to occur between the rear compartment antenna and the keyless entry transmitter. For more information about keyless access, refer to Keyless Entry System Description and Operation.
Warning: Refer to Approved Equipment for Collision Repair Warning in the Preface section. Warning: Refer to Collision Sectioning Warning in the Preface section. Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section. Disable the SIR System. Refer to SIR Dis ...
This information provides repair recommendations and general guidelines for steel classified as Mild Steel. This type of steel normally has a tensile strength less than 270 MPa. This includes the common steel names of: Mild Steel Bake Hardenable Steel (BH) Solid Solution Strengthened Stee ...
Frontal SIR System Description
The frontal supplemental inflatable restraint (SIR) system consists of the following components: AIR BAG indicator located in the instrument cluster Inflatable restraint sensing and diagnostic module (SDM) Inflatable restraint passenger presence detection system Inflatable restraint Pass ...