Chevrolet Cruze manuals

Chevrolet Cruze Repair Manual: Instrument Panel Tie Bar Replacement (Right Hand Drive)

Chevrolet Cruze Repair Manual / Body hardware and trim / Instrument Panel and Console Trim / Instrument Panel Tie Bar Replacement (Right Hand Drive)

Removal Procedure

  1. Remove instrument panel compartment. Refer to Instrument  Panel Compartment Replacement.

  1. Remove instrument panel wiring harness (2) from instrument panel tie bar (1).

Disconnect electrical connectors.

  1. Remove instrument panel tie bar (1).

Remove 4 instrument panel tie bar bolts (3, 4).

Remove 2 instrument panel tie bar nuts (2).

Installation Procedure

Caution: Refer to Fastener Caution in the Preface section.

  1. Install instrument panel tie bar (1).

    Install 4 instrument panel tie bar bolts (3, 4) and tighten to 22 N·m (17 lb ft).

    Install 2 instrument panel tie bar nuts (2) and tighten to 9 N·m (80 lb in).

  1. Install instrument panel wiring harness (2) to instrument   panel tie bar (1).

    Connect electrical connectors.

  2. Install instrument panel compartment. Refer to Instrument Panel Compartment Replacement.
Instrument Panel Assembly Replacement
Preliminary Procedures Disable the SIR system. Refer   to SIR Disabling and Enabling Remove the front floor console assembly. Refer to Front Floor Console Replacement. Remove ...

Instrument Panel Wiring Harness Replacement
Removal Procedure Remove instrument panel compartment assembly. Refer to Instrument   Panel Compartment Replacement. Remove instrument panel wiring harness (2) from instrume ...

Other materials:

SIR Inflator Module Handling and Storage Warning
Warning: When carrying an undeployed inflator module: Do not carry the inflator module by the wires or connector. Make sure the air bag opening points away from you. When storing an undeployed inflator module: Make sure the air bag opening points away from the surface on which the in ...

Shifting out of Park
This vehicle is equipped with an automatic transmission shift lock control system. The shift lock is designed to: • Prevent ignition key removal unless the shift lever is in P (Park) with the shift lever button fully released. • Prevent movement of the shift lever out of P (Park) unless the ig ...

Hood Hold-Open Rod Replacement
Warning: Refer to Hood Hold-Open Device Warning in the Preface section. Preliminary Procedure Remove the radiator grille reinforcement support. Refer to Radiator Grille Reinforcement Support Replacement. Hood Hold Open Rod Pivot (Qty: 2) Hood Hold Open Rod ...

© 2017-2021 Copyright www.crion.site